Standalone 10 bar Ultrasonic Tank Level Monitor TEK-687

The TEK-678 is a standalone Ultrasonic Monitor to display the liquid level in a tank below using a 10 bar.

This unit is is mounted on top of the tank, facing downward. It uses Ultrasonic pulses to view the

Overview
  • Touch-less Measurement
  • Typically used for: Diesel, Heating Oil, Lubricants, Water, Waste Water, Diesel Engine Fluid
  • Suitable for vented tanks up to 10ft (3m) high
  • Ultrasonic distance measurement
  • Measuring distance (4 inch / 10 cm – 10ft / 3 m)
  • Operating Temperature Range: -10°C – +60°C (14°F – 140°F)
  • Operating humidity: 0-100%
  • Size: 2.7 x 1 .6 x 5.6 inch (70 x 40 x 1 42 mm)
  • Accuracy +/- 1cm
  • Fits into standard hole sizes with pre-drilled 2″, 1 1/2″ or 1 1/4″ BSP/NPT openings
  • No maintenance necessary
  • Battery life: approximately 5 years (3V CR2430)
Main Features
  • 10 bar LCD display
  • Simple handling
  • Easy installation
  • Low power consumption
  • Simple installation
  • 1.5 and 2 inch thread fits for most tanks
FAQ
  • Does this equipment work for caustic liquids?
    Technically it does, since the ultrasonic sensor should not be in contact with the liquid. However over time the fumes of the liquid will cause the plastic housing to errode, which is why it is NOT recommended to use this gauge for caustic liquids.
    It is recommended to use a pressure probe based system instead.
    See Smart Box.
  • How does the unit get calibrated?
    The unit only shows the height displayed in 10% steps and does not measure the actual tank volume.

Operating Instructions: Operating Instructions

You can find this product in our Webshop:

http://shop.tankmonitoring.net/standalone-10-bar-graph-ultrasonic-tank-monitor.html